www.tekvox.com
4K PTZ Camera
79068-4K-12 User Manual
3.2 Remote Control
3.2.1 Match Code for Wireless Remote Control
One-to-One Code Matching:
Press the "set" and "*" keys combined for 3 seconds and the LED indicator will start
flashing. When the camera receives the signal and powers on, LED indicator will go
off if code matches successfully. The camera can be controlled by this wireless
remote control only after one-to-one code pairing. Otherwise, clear the code
matching this remote control, or use another remote control to pair with the
camera again.
If one-to-one code matching failed, the red LED will flash for 20 seconds and then
turn off, camera will stop code match and turn on sleep mode. Press any key to
wake up the camera and re-match code.
Note: After code matches successfully, select the camera address to control it.
Clear Code:
Press the "set" and "#" keys combined for 3 seconds, LED indicator starts flashing.
Camera will power off and on, and the LED indicator will go off if the code is
cleared successfully.
Sleep Mode and Wake Up:
Press any key to wake the camera from sleep mode.
3.2.2 Keys Introduction for IR Remote Control
1) In this manual, “press the key” means a short click rather than a long-press, and a special note will
be given if a long-press for more than one second is required.
2) When a key-combination is required, do it in sequence. For example, “[*] + [#] + [F1]” means press
“[*]” first and then press “[#]” and last press “[F1]”.
1. Standby Key
The camera enters standby mode if the standby key is pressed for 3s;
Long press for 3s again, and the camera will self-check again and return to the HOME position (If
preset 0 position is set, the camera will return to preset 0 position).
