Tektronix TMS 600 SAB-C167 80C167, Инструкция по эксплуатации

Страница: 31 / 94

TMS 600 SAB-C167 80C167 Microcontroller Support Instruction Manual
2–1
Setting Up the Support
This section provides information on how to set up the support. Information
covers the following topics:
H
Channel group definitions
H
Clocking options
H
Symbol table files
The information in this section is specific to the operations and functions of the
TMS 600 80C167 support on any Tektronix logic analyzer for which it can be
purchased. Information on basic operations describes general tasks and functions.
Before you acquire and disassemble data, you need to load the support and
specify setups for clocking and triggering as described in the information on
basic operations. The support provides default values for each of these setups,
but you can change them as needed.
Channel Group Definitions
The software automatically defines channel groups for the support. The channel
groups for the 80C167 support are Address, Data, Mnemonic, Control, Port2,
Misc0, Misc1, P7 (7-0), and P8 (7-0). If you want to know which signal is in
which group, refer to the channel assignment tables beginning on page 3–6.
Clocking Options
The TMS 600 support offers a microcontroller-specific clocking mode for the
80C167 microcontroller. This clocking mode is the default selection whenever
you load the 80C167 support.
A description of how cycles are sampled by the module using the support and
probe adapter is found in the Specifications chapter.
Disassembly will not be correct with the Internal or External clocking modes.
Information on basic operations describes how to use these clock selections for
general purpose analysis.
The clocking options for the TMS 600 support are: Write Mode and Alternate
Bus Master Cycles.