Tektronix TMS 600 SAB-C167 80C167, Инструкция по эксплуатации

Страница: 25 / 94

Getting Started
TMS 600 SAB-C167 80C167 Microcontroller Support Instruction Manual
1–9
CAUTION. Static discharge can damage the microcontroller, the probes, or the
module. To prevent static damage, handle all of the above only in a static-free
environment.
Always wear a grounding wrist strap or similar device while handling the
microcontroller.
2. To discharge your stored static electricity, touch the ground connector located
on the back of the logic analyzer. If you are using a test clip, touch any of the
ground pins on the clip to discharge stored static electricity from it.
3. Use Table 1–2 to connect the channel probes to 80C167 signal pins on the
test clip or in the SUT.
Use leadsets to connect at least one ground lead from each channel probe and
the ground lead from each clock probe to ground pins on your test clip.
Table 1–2: 80C167 signal connections for channel probes
Section:channel 80C167 signal Section:channel 80C167 signal
A3:7 P2.15* D3:7 T2IN*
A3:6 P2.14* D3:6 T3IN*
A3:5 P2.13* D3:5 T4IN*
A3:4 P2.12* D3:4 CAPIN*
A3:3 P2.11* D3:3 MRST*
A3:2 P2.10* D3:2 MTSR*
A3:1 P2.9* D3:1 TXD0*
A3:0 P2.8* D3:0 RXD0*
A2:7 A23 D2:7 CC31IO*
A2:6 A22 D2:6 CC30IO*
A2:5 A21 D2:5 CC29IO*
A2:4 A20 D2:4 CC28IO*
A2:3 A19 D2:3 POUT3*
A2:2 A18 D2:2 POUT2*
A2:1 A17 D2:1 POUT1*
A2:0 A16 D2:0 POUT0*
A1:7 A15 D1:7 D15
A1:6 A14 D1:6 D14
A1:5 A13 D1:5 D13
A1:4 A12 D1:4 D12