Tektronix TDS5032, Руководство пользователя

Страница: 25 / 248

Installation
Setting up the Instrument to Take Measurements
To set up the oscilloscope, follow these steps:
1. You must power on the oscilloscope for twenty minutes before you can start
to take measurements.
2. You must run the compensation signal path on the oscilloscope.
3. You must make sure that the default factory setup is recalled before you
start using the application in the oscilloscope.
To do so, push the recall
default setup button on the front-panel of the oscilloscope to recall the
default factory settings.
4. You should always use calibrated probes and degauss the current probes.
Recommended Instruments and Probes
For information on recommended instruments and probes, refer to the Optional
Application Software on Windows-Based Oscilloscopes Installation Manual .
Installing the Application
Refer to the Optional Applications Software on Windows-Based Instruments
Installation Manual for the following information:
Installing an application
Applying a new label
Enabling an application
Downloading updates from the Tektronix Web site
You can find a PDF (portable document format) file of this document in the
Documents directory on the
Optional Applications Software on Windows-Based
Instruments CD–ROM . The CD booklet only contains information on installing
the application from the CD and on how to apply a new label.
TDSUSB2 Universal Serial Bus Measurement Package
11