Tektronix Phaser 840, Руководство по обслуживанию

Страница: 60 / 207

Service Guide
49
2. Skew a. Last sheet in tray
b. First sheet in tray
c. Failure of deskew
system
a. Refill tray(s)
b. Make sure tray(s) is
loaded properly and
media is square in tray
c. Check deskew fingers.
If chronic, check
preheat entry assembly
for deformation.
3. Media perfectly straight a. Media path motor stall a. Use PC-based
diagnostics to run
“verify drive current
requirements” from the
paper path group to
check for stall, or feel for
unevenness in motor
rotation by manually
turning. Replace paper
path motor if needed.
Check electronics if
needed
22,644.11 Time-out on duplex sensor
1. Printer is pulling the
paper from the customer a. Customer tried to
remove media after first
side and didn't let it enter
the duplex path
a. Train the customer
2. Media damage left lead
corner a. Hitting the left wall under
control panel
a. Move front panel to left;
If necessary, replace
front panel assembly.
Replace printer if
chassis warped
3. More than one sheet in
duplex path a. Media was pulled from
exit into duplex while
printing
a. Empty exit tray
4. Excess skew a. Last sheet in tray
b. First sheet in tray
c. Failure of deskew
system
d. Exit roller is out of
position
a. Refill tray(s)
b. Make sure tray(s) is
loaded properly and
media is square in tray
c. Check deskew fingers.
If chronic check preheat
entry assembly for
deformation
d. Reseat exit roller
5. Media deformed or
damaged in media tray a. Left corner folded in tray
(simplex trailing edge)
b. Remove media, inspect
and reload
Error code
Additional clues Probable cause Action