Tektronix Phaser 840, Руководство по обслуживанию

Страница: 115 / 207

104 Phaser 840 and 850 Color Printers
Note
Do not insert both spacers at the same time as this will only
measure the larger of the two gaps.
9.
Remove the right printhead spacer and install the LEFT spacer between
the printhead and drum. Repeat the adjustment.
10.
Remove the spacer. Snug the four locking screws using an X-pattern.
Then tighten the four screws, using the same X-pattern, to 20 in.-lbs.
11. If not connected, plug the printhead’s data ribbon cable and power
wiring harness into the power control board. Inspect both ends of the
data ribbon cable to ensure they are properly seated.
12.
Recheck the gap at both ends of the printhead.
13. Remove the head-to-drum gap indicator and bracket from the frame.
14. Reinstall the ink loader and metal heat cover.
15. Select Complete from the front panel. Reinstall the top cover.
16. Print service test print Head-to-Drum Gap to check alignment.
Spacing the printhead to the drum
RIGHT
Tighten locking
screws when
both left and right
adjustments are
complete
Gap tool
Insert flatblade
screwdriver in
adjusting slot.
Use a twisting
motion to move
the printhead.
Position gap tool
between the printhead
and drum, hook in side
frame and over shaft
0388-31
Repeat adjustment
at this end of
printhead with
LEFT gap tool
Printhead in
print position