APPLICATIONS
The following applications are not described in detail, since
each application must be adapted to the requirements of the
individual measurement. This instrument can also be used for many
applications which are not described in this handbook. Contact your
local TEKTRONIX Field Office or representative for assistance in
making specific measurements with this instrument.
Voltage Measurements
1. AC Signals
a. Set the INPUT COUPLING switch to GND and the
VOLTS/DIV to an appropriate setting (VOLTS/DIV VAR to
CAL). Vertical deflection factor equals the product of the
VOLTS/DIV setting and the probe attenuation factor.
Without the addition of a probe attenuator, the vertical
deflection factor can be read directly from the VOL TS/DIV
switch (VOLTS/DIV VAR in CAL). Connect the probe tip
to the signal source and switch the INPUT COUPLING to
the AC position.
b. Select the desired SEC/DIV setting and adjust the Trigger
LEVEL/SLOPE control for a triggered display. Position
the display within the graticule area for measurement.
c. Measure the peak-to-peak amplitude of the display or
waveform, in graticule divisions (see Fig. 3).
24
212 Operators Handbook
