Instruction Manual
Tek-LCD 7801C
www.tek-trol.com
Technology Solutions
80
7
Ethernet
Full
Port Setup
CAUTION
Consult with your IT department to configure the Ethernet port and maintain
network security.
The Ethernet port option is fully configured using the Tek-Trol DeviceInstaller software, available
for download from the Tek-Trol’s Website.
https://www.Tek
-
Trol.com/products/xport
Follow these steps, after installation of the DeviceInstaller software.
1.
Connect an Ethernet cable to the Local Area Network
2.
Launch the Tek-Trol DeviceInstaller; it will search for XPort devices on the Local Area Network
(LAN) and display their status.
3.
If no controller is found, click on Options, and select the type of connection being used (e.g.
Wi-
Fi).
4.
If more than one controller is connected to the network, determine which is the new controller
by the assigned IP address. If necessary, disconnect the new controller and click Device –
Search, take note of the IP addresses listed. Next, connect the new controller to the LAN and
repeat the search; check the list to see which the new IP address is.
5.
Double-click on the new device IP Address to be configured.
To communicate with a device connected over a LAN, you need the IP Address and the Local
TCP Port.
