STEP 5
Assemble Cover Sets
Pedal Arm Joint Cover Sets Installation
• Locate the Pedal Arm Joint Cover Sets, noting Right and Left
markings. Pair each set over the corresponding Right and Left
Pedal Arm Joints (Figure 19).
• Use the
Step 5 Hardware Kit
to install the
Pedal Arm Joint Cover
Sets
. Partially tighten 2 × Phillips Head Screws on each set as
shown. Ensure they are properly aligned and proceed to fully
tighten the Phillips Head Screws with the Screwdriver
(Figure 19 and Figure 20).
FIGURE 19
FIGURE 20
FIGURE 17
FIGURE 18
Step 5 Hardware
Step 5 Hardware
60
Phillips Head
Screw
60
Phillips Head
Screw
Upper Front Leg Cover Sets Installation
IMPORTANT:
Make sure the Speed Sensor Wire sits under
the Left Upper Front Leg Cover Set and is not pinched
during installation.
TIP:
In order to gain better access to the screw holes while
assembling the Upper Front Leg Cover Sets, adjust the position
of the Pedal Arm Joints by pushing forward or pulling backward
on the Handle Support Tubes.
• Locate the Upper Front Leg Cover Sets, noting Right and Left
markings. Pair each set over the corresponding Right and Left
Upper Front Leg (Figure 17).
• Use the
Step 5 Hardware Kit
to install the Upper Front Leg
Cover Sets. Partially tighten 3 × Phillips Head Screws using the
Screwdriver provided on each set as shown. Ensure they are
properly aligned and proceed to fully tighten the Phillips Head
Screws with the Screwdriver
(Figure 17 and Figure 18).
10