FIGURE 12
STEP 4
Assemble Supports
Console Front Support Bar Installation
IMPORTANT:
Do not pull or pinch the Speed Sensor Wire during
the Console Front Support Bar Installation.
• Open the Battery Compartment located on the back of the
console. Ensure that the battery contacts and compartment
are clean. Locate the (2) included batteries (AA 1.5 V Alkaline)
and install them in the back of the Console in the Battery
Compartment, noting (+) and (-) symbols.
• Ensure that the Speed Sensor Wires remain on the outside. Align
both ends of the Console Front Support Bar with the Lower
Console Support Tube and insert (Figure 12).
• Carefully connect the Speed Sensor Wires (Figure 13).
• Use the
Step 4a Hardware Kit
to attach the Console Front
Support Bar. Hand tighten 4 × Bolts with 4 × Curved Washers
as shown. The Curved Washers should wrap around the shape
of the Lower Console Support Tube. Proceed to fully tighten the
Bolts with the Allen Wrench (Figure 14).
Handle Support Tube Installation
• Locate the Handle Support Tubes, noting Right and Left
markings
(Figure 15a)
. Insert the bottom of each Handle
Support Tube into the top of the Upper Pedal Arm (Figure 15b).
• Use the
Step 4b Hardware Kit
to attach the Handle Support
Tubes. Hand tighten 10 × Bolts with 10 × Curved Washers as
shown. The Curved Washers should wrap around the shape of
the Upper Pedal Arms. Proceed to fully tighten the Bolts with
the Allen Wrench (Figure 16).
FIGURE 13
FIGURE 14
FIGURE 15b
FIGURE 16
108
Bolt
109
Curved Washer
108
Bolt
109
Curved Washer
Step 4a Hardware
Step 4b Hardware
9
LEFT/RIGHT
REVISIONS
ENGR
DATE
REV SHT ZONE
DESCRIPTION
NMS
10/18/2017
A
1
8D A1: RELEASE FOR PATENT
PARTS LIST
ITEM QTY
NET DIMENSIONS/DESCRIPTION
NOTE
MATERIAL
SHT
REVISION STATUS
SHT
1
REV
A
8
A
1
2
3
4
5
6
7
D
C
B
C
A
D
B
5
3
1
6
2
4
8
7
8
A
1
2
3
4
5
6
7
D
C
B
C
A
D
B
5
3
1
6
2
4
8
7
handle assy
SHEET 1 OF 1
REV
PROJECT:
DRAWN
UNLESS OTHERWISE NOTED
SURFACE ROUGHNESS PER ANSI B46.1
DIMENSIONING PER ASME Y14.5-2009
WELD SYMBOLS PER AWS A2.4
FINISH:
UOS 63RMS ON
MACHINED
SURFACES OR
AS PROCURED
.X
.XX
.XXX
ANGLE
EXPECTATIONS PROPRIETARY
THE INFORMATION CONTAINED HEREIN
IS PROPRIETARY TO EXPECTATIONS AND
SHALL NOT BE REPRODUCED IN WHOLE
OR IN PART OR USED FOR ANY PURPOSE
EXCEPT WHEN SUCH USER POSSESSES
DIRECT WRITTEN AUTHORIZATION
FROM EXPECTATIONS LLC
SCALE: FULL SIZE:
D
A
TOLERANCES
UNLESS NOTED
= .1
= .03
= .005
= 1
NICK SOLLER
FILLET RADII: .005-.010
CORNER BREAK: .005-.010
ALL DIMENSIONS IN INCHES
EXPECTATIONS LLC
PUYALLUP, WA 98391
DRAWING
PROJECT NAME HERE
FIGURE 15a
LEFT / RIGHT