TS1001 Touch Screen Arming Station Installation Manual
7
Figure 5: Use of plasterboard mounting bracket
(1)
Plasterboard mounting bracket
(2)
Wall cavity (115 x 82 mm)
To install the RAS:
1. Use the mounting template to locate the cavity to be cut in the plasterboard
and the holes (or notches) for the self-tapping mounting screws to pass
through the plasterboard to the mounting bracket.
2. Cut the cavity in the plasterboard, and drill holes (or cut notches) for the
screws.
3. Pass the mounting bracket into the cavity, hooking the tabs at the bottom over
the edge of the plasterboard (facing you).
4. Remove the two body retaining screws (Figure 1 on page 1, item 7), and set
aside for reuse.
5. Pull the bottom of the body away from the base to disengage the tabs at the
top, and then remove the body assembly from the base assembly.
6. Set the RAS address using DIP switches 1 through 4 (see
“DIP switches” on
page 8).
7. Set the LAN termination using DIP switch 8, if required (see
“DIP switches” on
page 8).
8. Terminate the cabling.
Note:
All power should be turned off to the Challenger
panel before wiring the RAS.
9. Insert the base assembly into the cavity, and then secure it to the mounting
bracket via the self-tapping screws (supplied).
10. Hook the top of the body onto the mounting tabs on the base, and then swing
the bottom of the body into position to align the retaining screw holes at the
bottom.
11. Replace the two body retaining screws to secure the body to the base.
