TS1001 Touch Screen Arming Station Installation Manual
v
Advisory messages
Advisory messages alert you to conditions or practices that can cause unwanted
results. The advisory messages used in this document are shown and described
below.
WARNING:
Warning messages advise you of hazards that could result in injury
or loss of life. They tell you which actions to take or to avoid in order to prevent
the injury or loss of life.
Caution:
Caution messages advise you of possible equipment damage. They tell
you which actions to take or to avoid in order to prevent the damage.
Note:
Note messages advise you of the possible loss of time or effort. They
describe how to avoid the loss. Notes are also used to point out important
information that you should read.
Related manuals
This manual describes how to install and configure the TS1001 Touch Screen
Arming Station. Arming stations are also known as remote arming stations or
RASs. Refer also to the
TS1001 Touch Screen Arming Station User Manual
for
details about using the Touch Screen RAS.
The Touch Screen RAS may be used on the Challenger series control panels
(ChallengerPlus, Challenger10 or a Challenger V8). Refer to the appropriate
Challenger manual for details about operating the Challenger system.
Care and cleaning instructions
The touch screen display panel (Figure 1 on page 1, item 1) is an LCD module
consisting of a glass display panel and a polarizing display surface. The polarizer
covering the display surface of the LCD module is soft and easily scratched.
Do not use hard or sharp objects to operate the touch screen: it is designed to be
operated by touching the display surface with your fingers (or gloved hands).
If the touch screen is dirty, breathe on it to fog the surface, and then gently wipe
the surface with a soft dry cloth.
Caution:
Do not use water, ketone, or aromatic solvents to clean the touch
screen.
For dirt or marks that are not removed by a soft dry cloth, moisten the cloth with a
small amount of either isopropyl alcohol or ethyl alcohol, and then gently wipe the
surface.
WARNING:
Do not use alcohol near an open flame or other source of ignition.
