TECO E510-201-SH, Инструкция по эксплуатации

Страница: 8 / 425

1-2

RCD is required to be in compliance with the protection norm of B-type leakage
current.

Please check and test emergency stop circuits after wiring. (Installer is responsible
for the correct wiring.)

Never touch any of the input or output power lines directly or allow any input of
output power lines to come in contact with the inverter case.

Do not perform a dielectric voltage withstand test (megger) on the inverter this
will result in inverter damage to the semiconductor components.
Caution

The line voltage applied must comply with the inverter’s specified input
voltage.

Connect braking resistor and braking unit to the designated terminals.

Do not connect a braking resistor directly to the DC terminals P (+) and N (-),
otherwise fire may result.

Use wire gauge recommendations and torque specifications.

Never connect input power to the inverter output terminals U/T1, V/T2, W/T3.

Do not connect a power factor correction capacitor or surge suppressor to the
inverter output.

Ensure the interference generated by the inverter and motor does not affect
peripheral devices.
Danger

When the momentary power loss is longer than 2 seconds, the inverter will not
have sufficient stored power for its control circuit. Therefore, when the power is
re-applied, the run operation of the inverter will be based on the setting value of
parameter 00-02(or 00-03) and 07-04 status of external run switch.

When the momentary power loss is shorter, inverter still can control the power.
Therefore, when the power is re-applied, the run operation of inverter will be
based on the setting value of parameter 07-00.

When the power is re-applied, the run operation of inverter will be based on the
setting value of 00- 02(or 00- 03), 07- 04 and the status of power and operation
switch(FWD/REVswitch)(and 07- 00/07- 01/07- 02)：
(1) If the parameter 00-02(or 00- 03)=0, inverter will not start automatically
when the power in re-applied.
(2) If the parameter 00- 02(or 00- 03)=1 and the power or operation switch is
open, inverter will not start automatically when the power is re-applied.
(3) If 00- 02(or 00- 03)=1, then power and operation switch are open
(07- 04=0), inverter will restart automatically when the power is re-applied.
For the safety, please turn off the power and operation switch after powered
off.

For the safety, please read the function explanation from the manual.
1.3 Before Operation
Caution

Make sure the inverter model and rating are the same as that set in parameter
13-00.