TECNA TE 500, Руководство пользователя

Страница: 40 / 52

40 / 52
Use expansion card ITEM 50214 to connect the TE500 with a printer or a PC fitted with RS232 serial
interface to document production data.
The card interfaces with the control unit by means of a 6-pin connector and with the printer (or
computer) by means of a standard female 9-pole connector. The 9-pole connector is wired as follows:
PIN 1 CD (ALWAYS ON)
PIN 2 TRANSMISSION (TD)
PIN 3
RECEPTION (RD)
PIN 4 DTR (ALWAYS ON)
PIN 5 MASS (GROUND SIGNAL)
PIN 6 DSR (ALWAYS ON)
PIN 7 RTS
PIN 8 CTS
PIN 9 NOT CONNECTED
PIN1 GROUND (GROUND FRAME)
PIN2 TRANSMISSION (TD)
PIN3 RECEPTION (RD)
PIN 4 TRANSMISSION REQUEST (RTS)
PIN 5 READY AT START (CTS)
PIN 6 DATA READY (DSR)
PIN 7 MASS (GROUND SIGNAL)
PIN 20 TERMINAL READY (DTR)
SPEED 9600 BAUD
WORD LENGTH 7 BIT
PARITY EVEN
STOP BIT 1
SERIAL INTERFACE RS-232 ITEM 50214 (Option)
On request, cable Art. 70377 is available for the connection with standard serial printers that as a rule
are equipped with a female 25-pole connector as follows:
The control unit does not execute any type of handshaking at the serial port. The serial port of the
printer must be configured with the following values:
The control unit runs the data transmission at the beginning of the OFF time. Keep in mind that the
time used for printing data is approximately 20 ms and such time will be added to the set OFF time.
A specific parameter in the special functions menu permits to choose whether or not to activate the
print. The following items are printed for each weld:
$
Welding program number
$
Number of cycles with which the weld was carried out
$
Welding current
$
Welding current conduction angle
$
Progressive spot number
$
Out-of-limit spot signal
When the control unit is powered, every time a programming value is edited and when the key selector
is switched from PROGRAM to RUN the control unit prints the header and the values of the parameters
of the selected program.