Techsys SWORDFISH+, Руководство по эксплуатации

Страница: 37 / 61

www.techsys.com.au Version 1.3 11/12/11
37
C o r p o r a t io n
•
System Paused
The “system pause” input is activated
•
Low Alarm
If a Low Level circumstance has occurred then the output will turn on.
•
High Alarm
If a High Level circumstance has occurred then the output will turn on.
•
Any Alarm
If there are any Fault Re-starts active or general alarm that do not cause a system
shutdown this output will activate.
•
Any Pump Shutdown
If any pump is shutdown this will then will activate the relay.
•
Any Pump Running
Any pump running will activate the relay.
•
Trip Point
When the system level reaches the nominated Trip Point Low and High, this relay will
energize or de-energize. See level Trip in SETTINGS.
•
Alternate Trip
Each time the system shuts down the energized state of the relay will change. E.g. If the
relay on one cycle is closed during operation then the next cycle this relay will be open.
The relay will change on the following: - Low level Shutdown, High level Shutdown, No
Flow Shutdown and Pause.
•
Aux Outputs 1 - 3
Any output can be set to be an auxiliary output. Setting an output to become an auxiliary
output allows the SWO to use an input to turn on a Digital Output. To do this
the input has to be set up to be an Auxiliary input. There are three auxiliary functions
available.
Aux Input 1 operates Aux Output 1
Aux Input 2 operates Aux Output 2
Aux Input 3 operates Aux Output 3
* RELAY RATINGS
The relays are rated at 5 amp 250VAC. Consideration of inrush current, inductive loads
and cycling must be taken into account when applying current to these relays.