AutoGRAPH ON-BOARD CONTROLLER • USER MANUAL
47
TechnoKom © 2016
Bluetooth connection
AutoGRAPH on-board controllers of a hardware version 3.0 are equipped with Bluetooth
module which allows to connect external devices to the tracker wirelessly. All connected
devices and sensors must be Bluetooth Smart compatible.
Current version of AutoGRAPH trackers supports wireless connection of TKLS fuel level
sensors of TechnoKom production.
Detailed instruction for configuration of Bluetooth module of AutoGRAPH trackers is given in
the document “Configuration and Setup. AG.GSMConf software”.
i
NOTE
Before connection, it is necessary to set up Bluetooth options – specify addresses of
connected TKLS sensors and set up data recording period for those sensors.
To connect TKLS sensor to AutoGRAPH controller via Bluetooth, follow the next steps:
•
set all connected sensors up;
•
set Bluetooth options of AutoGRAPH tracker up;
•
mount TKLS sensor in a tank following the instructions given in User manual for the sensor,
then connect power supply to the sensor;
•
connect power supply to AutoGRAPh controller. After turning on and initializing all modules,
AutoGRAPH controller will start searching for available sensors via Bluetooth. Then it will
automatically connect to devices which have been found, if their are compatible with the
trackers firmware;
•
after that the controller will record readings of connected sensors in internal memory with
the specified recording period and transfer collected reading to data server along with other
data. Data is transferred to server with a regular period of by a preset event.
To connect TKLS fuel level sensors to AutoGRAPH controller via Bluetooth, the controller firmware
must be AGEX-12.12 or higher and firmware of TKLS sensors must be TKLS-01.38 or higher.
IMPORTANT
