46
>
Fill the holes with some of the mounting adhesive, screw the base plate down with the 4x16 screws and then apply
some mounting adhesive to the screws to seal the holes.
Make sure that the mounting adhesive does not protrude beyond the surface of the base plate.
>
Apply a thin seam of mounting adhesive around the edge of the base plate, smooth it out and remove the adhesive
tape.
>
Place the alignment unit back on the base plate and screw together using the 4 nuts.
>
Find a suitable position for the cable support / cable duct through the vehicle roof.
Be sure to pay attention to any installations that possibly exist on, in and under the vehicle roof.
Also note that the closed, rounded side of the cable holder must be facing in the direction of travel.
>
Mark the position by applying a strip of tape around the cable holder.
46
Содержание SKYRIDER 65
