TechniSat SKYRIDER 65, Инструкция по эксплуатации

Страница: 53 / 172

53
DE
EN
FR
IT
NL
PL
12.3 Setting up the satellite system and aligning it with a satellite
> First use the arrow keys to select the desired satellite, unless the LED associated with the desired satellite is already lit.
> By pressing the SET button, the satellite system automatically extends and aligns itself to the satellite if it was in the
home position.
The lock LED flashes to signal that the SKYRIDER 65 is pointing at the desired satellite. After successful alignment, the
lock LED and the LED associated with the satellite will light up.
Switching to other satellites is also possible by using DiSEqC (see point 5.5) together with your receiver, so that you do
not have to resort to using the remote control of the controller or make the selection on the controller itself.
12.4 Home position / retracting the satellite system
It is essential to retract the satellite system before moving the vehicle, otherwise it could be damaged by obstacles or
the wind. If this did not happen automatically when the vehicle ignition was switched on, you must start the retraction
procedure manually.
> With the controller turned on, press the HOME button on the controller or the remote control to retract the satellite
system.
The Home LED flashes to signal that the SKYRIDER 65 is retracting. After the retraction process has ended, the Home LED
lights up continuously. The controller can now be switched off and the vehicle can be moved.
If the satellite system is in the Home position and the controller was not switched off afterwards, it will switch off
automatically after 15 minutes of idleness.
The satellite system must not be extended while driving.