TechniSat SKYRIDER 65, Инструкция по эксплуатации

Страница: 47 / 172

47
DE
EN
FR
IT
NL
PL
> Drill a hole in the vehicle roof within this marked area with the 25mm drill bit to be able to pull the cables of the satellite
system into the vehicle interior.
> Connect the signal cable or, with the twin LNB version, both signal cables to the signal connection / connections of the
satellite system (see connection diagram point 4.4.3) and push the rubber grommet(s) up to the stop.
> Remove the nut, the screw cap and the rubber seal from the cable screw connection.
> Slide the nut from below into the holder on the inside of the cable holder and screw in the cable screw connection.
> Slide the screw cap over the signal cable(s) and the control cable and insert the cables from the side into the rubber
seal.
> First push the control cable and then the signal cable(s) through the cable screw connection and the drilled hole.