AIMA3000.FRAS Product User Manual
Technetix Group Limited
•
technetix.com
May/2016 - Version 1.0
31
(d) Mounting the Redundancy Cable Assembly to the Chassis
1.
Unfasten the screw in figure (a);
2. Fasten the sub assemblies of redundancy cable brace in figure (b), and then insert the USB connector of the
redundancy cable to it, as shown in figure (c).
3. Mounting the assembly of redundancy cable and its brace to the brace mounting holes on chassis by tightening
the securing screw, as shown in figure (d).
5.6 Check Module LEDs
When the module has been installed and power is supplied from the chassis, the status LEDs will show a blinking green
light indicating that module has started. After 15 seconds if the input signal is normal, the module STAT status LED should
show a green light. The optical input indicator will show a green light. If there is no signal then the module STAT and the
corresponding port status indicators will show a red light.
