AIMA3000.FRAS Product User Manual
Technetix Group Limited
•
technetix.com
May/2016 - Version 1.0
24
3. After the module is inserted, gently push the hinged tab until it snaps into the orange retaining clip. While
.......
pushing down on the hinged tab, the AIMA module will mate with the power bus and will lock in into the chassis
CAUTION!
If force is required to insert a module, then it may not be correctly seated on the slide rails, or the mounting screw may
be misaligned.
4. When the module is fully seated within the chassis, on the bottom of the AIMA module, fasten the spring-loaded
mounting screw. Only use fingers to fasten the mounting screw. DO NOT use a screwdriver.
5.4 Connecting Optical Cables
For the convenience of the user, the AIMA3000 chassis has a Sliding Fibre Guide to help the operator to arrange the
cables. For the specific steps to connect the fibre, please refer to the instructions in section 5.4.1.
5.4.1 Using the Sliding Fibre Guide
The sliding fibre guide is located in the lower-left corner of the chassis if looking at the front of the chassis and is
designed to help installation of the optical fibre cabling. To access the sliding fibre guide you will need to first remove the
rear panel located on the back of the chassis.
1.
Unscrew the two thumbscrews on the rear panel.
