P A G E 9
D I P A N D F L O W C O O L E R S U S E R ’ S M A N U A L
Flow Coolers
The FC-200 and the FC-500 are designed to work with the Techne
C-85 circulator to give the temperature control. They are normally
used to give circulation round a closed loop system, but may also be
used in the open tank situation where the use of a dip cooler is
impractical.
The Flow Coolers use a refrigerant which is circulated through a
compact heat exchanger which has inlet and outlet pipes for the
working liquid on the rear of the unit. These pipes are 16mm
diameter. The flow coolers need a minimum flow rate of 10 litres/
min at 20
o
C to prevent freezing in the heat exchanger.
OUTLET
INLET
Operator Safety
All users of Techne equipment must have available the relevant
literature needed to ensure their safety.
It is important that only suitably trained personnel operate this
equipment, in accordance with the instructions contained in this
manual and with general safety standards and procedures.
Techne refrigerated units have been designed to conform to
international safety requirements.
If there is any doubt relating to the proper use of this equipment, the
staff at Techne will be pleased to assist you.
