2-8
EM18-33017
2. MAJOR UNIT REPLACEMENT
2.7 REPLACING THE ROLLER BELT AND FEED ROLLER
1) Lower the pinch roller lever.
2) Remove the white screw to detach the ribbon end sensor plate.
3) Remove the FL-3 x 5 screw, cut the cable band and remove the head-up switch.
4) Detach the connector of the ribbon end sensor.
5) Removal the pinch roller block.
NOTE:
Fit both sides of the studs into the notches when installing the ribbon end sensor plate.
6) Remove the four E-rings (E-5), pinch roller holder, bush, pinch roller washer, and then roller belt.
Pinch Roller Block
Stud
Connector
Cable Band
FL-3 x 5
White Screw
Ribbon End Sensor Plate
Notch
Head-Up Switch
Pinch Roller Lever
Fig. 2-12
E-ring (E-5)
Bush
Pinch Roller Holder
Pinch Roller Washer
Roller Belt
E-ring (E-5)
Fig. 2-13
2.7 REPLACING THE ROLLER BELT AND FEED ROLLER
