7
TEC-61231-23 Technical Manualе
PRIZRAK
PIN code
PIN code
is a secret combination of presses on one or more
original buttons in the vehicle. Please refer to the Integrator files for the
list of original buttons that can be recognized by the system in a specific
vehicle. PIN code is entered before driving the vehicle.
PIN code is a one-, two-, three- or four-digit number.
PIN code can be easily changed many times by both technical
specialists during installation of the system or by user during day-to-
day use of the vehicle.
To ensure a proper security level, the factory default PIN code
should be changed. If you don’t do it, an alarm will sound after
entering the PIN code, which reminds you to change the PIN code.
The factory default PIN code is "2"; it is entered by using the Programming button (please see the Integrator).
Entering the PIN code
PIN code is entered with the ignition (or engine) turned on by pressing original buttons. When entering one of the PIN digits, please make
sure that pressing time or pause are no longer than 1 second. Please keep a pause of approximately 2 seconds in between digits. If you made
a mistake while entering the PIN code, a warning will sound in about 3 seconds, then you can re-enter the PIN code.
PIN code entry sequence
•
Turn on the ignition or start the engine
•
Enter PIN code
•
Wait for the confirming trill.
Available PIN options
Buttons , , , , are used here as an example. Request the list of avaliable buttons in your vehicle at your shop.
One-digit PIN:
Two-digit PIN:
~2 second pause
Single-button PIN entry
When entering the PIN code keep in mind the entering sequence.
One-digit PIN:
Two-digit PIN:
~2 second pause
PUK code
PUK code is required if:
•
You have lost the RFID tag or lost/forgot the PIN code
•
You want to change identity verification method.
After PUK code is entered, all security functions of the Alarm will
be deactivated regardless the selected authentication method. PUK
code can be found under the scratch layer on the plastic card.
The factory set PIN code is "2"; it is entered by using the Programming button (please check the Integrator).
PUK-code entry
PUK code is entered by the Programming button with a 2 second pause in between keystrokes.
Entering sequence:
•
Turn on the ignition or start the engine
•
Enter PUK code
•
Wait for the confirming trill.
Maintenance mode
Maintenance is an operation mode when all hijack protection and
service functions of the Alarm are temporarily disabled.
The Alarm will notify of activation of the Maintenance mode as
follows:
•
When disarming, LED will turn on
•
When the ignition is turned on, LED will go out
•
After identity verification an alarm will sound
•
After the ignition is turned off, LED will light up and will be on
for a while.
To activate or deactivate the Maintenance mode follow these
steps:
1.
Turn off the ignition.
2.
Follow through with identity verification.
3.
Press the Programming button 6 times (you should start within
10 seconds after verification).
4.
Wait for confirmation of your actions:
•
If the Maintenance mode is on, the system will emit 1
audio signal, 1 light signal and a trill
•
If the Maintenance mode is off, the system will emit 2
audio signals, 2 light signals and a trill.
Automatic deactivation of the Maintenance mode
This function automatically disables the Maintenance mode after
a 10 km run. So even if you forget to disable this mode in the service
station, it will still be automatically disabled.
If Maintenance mode is activated by PUK code, it cannot be
automatically disabled.
If the vehicle does not support Speed control, automatic
deactivation of this feature will not be avaliable.
