48
2.
Grasp the input roller module tab, and pull it out of the printer.
3.
Clean the new input roller assembly before replacing it back in the printer. Clean with an
alcohol cotton swab in the direction pictured.
4.
Once the dust and debris is cleaned from the rollers, place the assembly module back into
the printer. Push in until it hits the stops. Close the front access panel.
D-2 Replacing the Print Head
The print head replacement comes with a floppy disk which contains important data. To ensure
the best print quality, the data must be loaded to the printer prior to printing.
Caution
IMPORTANT!
Be sure the printer has adequate cooling time before proceeding
with this section as the print head may be hot. This component is very sensitive
to static voltage and must not be touched with anything other than a cleaning pen.
1.
Press ―Ribbon Change‖ on the control panel once to lift the print head. This allows for
removal of the printer ribbon.
Figure D-2: Grasp input roller module
Figure D-3: Clean input roller assembly
