18
19
13
14
15
16
17
8
B
B
B
B
BA
A
A
A
AG
G
G
G
G A (Contin
A (Contin
A (Contin
A (Contin
A (Continued)
ued)
ued)
ued)
ued)
2
Step A-4
1. Insert a 3/32" x 3/16" Ball Bearing (13) into each of the two,
angled holes in the bottom of the front Kickplate (14). Insert the other
two Bearings into the two outer holes in the Steering Brace (15).
2. Insert a 3/32" x .930" Hinge Pin (16) through the hole in the
steering Idler Arm (8) and center the Hinge Pin in the Idler Arm.
Place the Servo Saver assembly and the steering Idler Arm into the
Bearings in the Kickplate so that the installed Draglink is to the front
as shown in Figure 4.
3. Place the Steering Brace on top of the Servo Saver assembly
and steering Idler Arm ensuring that the Ball Bearings slide over the
Pins.
There is a short Thread-Cutting Screw included in the Wrench
bag. This Screw can be used to tap threads in the holes in the Kickplate.
Pre-tapping these holes makes it easier to install the Screws during
assembly.
4. Secure the Steering Brace to the Kickplate using two 4-40 x
3/8" Cap Head Screws (17).
1. Install a Threaded Insert (18) into the top of each of the two
forward holes in the main Chassis (19). The inserts should be in-
stalled with the hex-side up as shown in Figure 5. Press the Threaded
Inserts all the way into the holes in the Chassis, lining up the hex on
the inserts with the hex in the holes.
Step A-6
There is a short Thread-Cutting Screw included in the Wrench
bag. This Screw can be used to tap threads into the back two holes in
the front part of the main Chassis. Pre-tapping these holes makes it
easier to install the Screws during assembly.
IMPORTANT NOTE:
Ensure that the hex of the Threaded
Insert remains seated in the hex area on top of the Chassis.
1. Attach the front Kickplate (14) to the bottom of the main Chas-
sis (19). Align the four holes in the Kickplate with the four holes in
the main Chassis. Secure the Kickplate to the Chassis by threading
two 4-40 x 3/8" Cap Head Screws (17) through the forward holes and
into the Threaded Inserts (18). Thread two more 4-40 x 3/8" Cap
Head Screws through the two rear holes of the Kickplate and into the
Chassis.
*NOTE: After completion of this bag, there will be some left-
over parts which will be used in a later step in this manual.
Figure 6
Figure 4
Figure 5
Step A-5
13
17
18
17
Steering Install:
Threaded Insert Install:
Kickplate Install:
16
14
17
19