B
B
B
B
BA
A
A
A
AG E
G E
G E
G E
G E
1. Place a drop of Shock Fluid (127) on the grooved end of each
Shock Shaft [front (118), rear (119)]. Then slide Shock Shaft through
hex end of an assembled Shock Cartridge Body (114). Slide the Shaft
through until it is approximately midway between the threads as and
the grooved end as shown in Figure 42.
20
Figure 42
Step E-1
Step E-2
Figure 43
Shock Shaft Install:
Shock End Install:
118
122
120
119
1. Carefully snap a 1/4" aluminum Shock Mount Ball (122) into
each of the Shock Ends on each of the Shafts.
2. Using needle-nose pliers, or small vise grips, grasp the front
Shock Shaft (118) between the grooves and thread a Shock End (120)
onto the Shock Shaft. Thread the Shock End all the way onto the
Shaft until the threads stop.
IMPORTANT NOTE:
Use caution when threading the Shock
Ends onto the Shafts. Avoid gouging or scratching the Shock Shaft
while gripping Shock Shaft with the pliers. By placing a towel over
the shaft, then gripping the portion of the Shaft covered by the towel.
This will work very well to protect the Shock Shaft.
3. Repeat Step 1 and 2 for the second front Shaft and two rear
Shafts.
122
118
119
118 119
114
