408-35043
Rev
D
19
of 30
7. If the feed pawl reaches the backstroke position before the slide hits the rear stop adjustment
screw, adjust the rear stop adjustment screw.
a. Loosen the rear stop locking screw (Figure 19).
b. Turn the rear stop adjustment screw clockwise until it meets the slide.
c. Verify that the feed pawl is in the backstroke position.
d. Tighten the locking screw.
NOTE
Use a 2.5mm ball end hex key wrench to adjust the feed stroke and feed positions. One-quarter turn of the rear stop
adjustment screw adjusts the backstroke 0.20mm (0.008 inch).
Figure 18: Rear stop locking screw
1
Rear stop adjustment screw
2
Rear stop locking screw
8. If the slide hits the rear stop adjustment screw before the feed pawl reaches the backstroke
position, adjust the rear stop adjustment screw.
a. Loosen the rear stop locking screw.
b. Turn the rear stop adjustment screw counter-clockwise.
c. Push the slide against the rear stop adjustment screw.
d. Verify that the feed pawl is in the backstroke position. If not, repeat substeps b and c.
e. Tighten the locking screw.
9. Extend and retract the slide by hand. Verify that the feed finger is in the backstroke position. If
not, repeat steps 7 and 8 to adjust the feed stop position of the feed finger.
10. Apply pressurized air to the air feed module.
11. Cycle the terminator in jog mode or by hand until the feed pawl retracts.
12. Verify that the pawl is in the correct location. If not, repeat steps 6 through 10.
