Doc. No: 412-121033
BTT-02 card printer manual
Issue: 1
Date: Jul 2014
Author: Ian Ridgeway
Issue date:
Aug 2014
Page: 17 of 18
While TE Connectivity has made every reasonable effort to ensure the accuracy of the information in this document, TE does not guarantee that it is
error-free, nor does TE make any other representation, warranty or guarantee that the information is accurate, correct, reliable or current. TE reserves
the right to make any adjustments to the information contained herein at any time without notice. TE expressly disclaims all implied warranties
regarding the information contained herein, including, but not limited to, any implied warranties of merchantability or fitness for a particular purpose.
The dimensions in this document are for reference purposes only and are subject to change without notice. Specifications are subject to change
without notice. Consult TE for the latest dimensions and design specifications.
If this document is printed it becomes uncontrolled
4.2 Solving print quality problems
To ensure even print quality use only the thermal transfer ribbon recommended by
the manufacturer
4.2.1 Unprinted, grainy, or incorrectly coloured areas
Any of these problems can occur due to uneven card material, or when dirt particles
remaining on the card surface after the card has passed the cleaning rail.
In these cases, change the cleaning reel and, if necessary, contact your card
supplier.
4.2.2 Unevenly printed card edges
Unevenly printed card edges can be due to card edge 'burr'. The problem can be
solved by using other cards, or not printing too close to the edge. If necessary
contact your card supplier.
4.2.3 Alterations in print quality following a change of thermal
transfer ribbon
Below are possible reasons for lack of contrast following new ribbon installation
(despite working to manufacturer's specifications):
-
The ribbon was stored too long (Ribbons have a six month shelf life.)
-
Check the print parameter
4.2.4 Horizontal lines
It is imperative to clean the print head immediately
if unintentional white lines or dots
appear in the print area.
If the problem persists after cleaning the print head, the print head is defective and
must be changed.
