Wrap-Around Guard
Wrap-Around Guard
Mounting Screw(s)
Terminating
Machine Base (Ref)
Wrap-Around Guard
Wrap-Around Guard
Mounting Screw(s)
Terminating
Machine Base (Ref)
408-32027
6 of 11
Rev A
Figure 6
5. With reel of terminals installed on reel support,
feed terminal strip into applicator between strip
guides.
NOTE
i
Be SURE terminal strip enters strip guides with
barrel (wire) end toward the stock drag and the
open side up.
6. Raise feed pawl and continue to feed terminal
strip until LEAD terminal is over anvil and feed pawl
engages hole in carrier strip.
7. Turn terminal drag downward to lower the stock
drag.
8. Be sure tip of feed pawl is in feed hole in carrier
strip. Note that some carrier strips have additional
holes which are not used for feed purposes.
9. Close the terminator guard doors.
4.2. Terminal Strip Unloading
1. Turn "off" and disconnect power to the terminator.
2. Be sure ram assembly is all the way up. If
necessary, hand-cycle machine to raise the ram.