409-35036
Rev A
9
of 15
4 Installation
NOTE
For a double-acting cylinder, use two hoses. One hose connects the pressure ports of the pump and cylinder, and the other
hose connects the retract ports.
1. Apply Teflon tape (or another suitable sealant) to the thread of the hose fitting. Wrap the tape around
the fitting 1½ times.
CAUTION
Trim loose ends from the tape. Leave the first thread free of tape so that it does not shed into the hydraulic system.
2. Insert the male coupling of the hydraulic hose into the female coupling on the pump.
3. Tighten the cap nut on the pump (Figure 3).
Figure 3: Tightening the cap nut
4. For improved safety and control, install a pressure gauge in-line from the pump.
5. Connect the other end of the hose to your tool or cylinder. If the tool is equipped with a male coupling,
use an adapter (Figure 4).
Figure 4: Hose adapter
1
Socket coupling
2
Adapter
