TDK-Lambda RWS 1500B Series, Инструкция по эксплуатации

Страница: 7 / 23

INSTRUCTION MANUAL
RWS1000B
•
1500B Series
TDK­Lambda
<Page>
/S
CN83 : Remote ON/OFF control
CN84 : Remote ON/OFF control
Standby supply
* CN83, CN84 Connector (JST)
Each other terminals are same as standard model.
These are connected by short pieces at time of shipment.
CN83 : "+Vm" terminal (Pin No.1) to "+S" terminal (Pin No.2)
"­Vm" terminal (Pin No.9) to "­S" terminal(Pin No.10)
CN84 : "+R" terminal (Pin No.3) to "+STB" terminal (Pin No.6)
"­R" terminal (Pin No.4) to "­STB" terminal (Pin No.10)
7/23
No. Configuration Function
1 +Vm
Output monitor terminal (+V). Internally connected to +Output terminal.
(+Vm terminal can not supply load current.)
2 +S
Remote sensing terminal for +output.
(For remote sensing function, which compensates for line drop between
power supply terminals and load terminals. Connect to +Vm terminal when
remote sensing function unnecessary.)
3 +R Remote ON/OFF control terminal.
4 ­R GND for Remote ON/OFF control terminal.
5 NC No cnnection
6 NC No cnnection
7 NC Do not connect. If connected may cause miss operation.
8 NC No cnnection
9 ­Vm
GND for Output monitor terminal. Internally connected to ­Output
terminal. ( ­Vm terminal can not supply load current.)
10 ­S
Remote sensing terminal for ­output side.
(For remote sensing function, which compensates for line drop between
power supply terminals and load terminals. Connect to ­Vm terminal when
remote sensing function unnecessary.)
No. Configuration Function
1 NC No cnnection
2 NC No cnnection
3 +R Remote ON/OFF control terminal.
4 ­R GND for Remote ON/OFF control terminal.
5 +STB Standby supply (5V/1A).
6 +STB Standby supply (5V/1A).
7 NC Do not connect. If connected may cause miss operation.
8 NC No cnnection
9 ­STB GND for Standby.
10 ­STB GND for Standby.
9
7
5
3
1
8
6
4
2
10
CN83
9
7
5
3
1
8
6
4
2
10
CN84
11
10