TDK-Lambda RWS 1500B Series, Инструкция по эксплуатации

Страница: 22 / 23

INSTRUCTION MANUAL
RWS1000B
•
1500B Series
TDK­Lambda
<Page>
8. Wiring Method
(1) The output load line and input line shall be separated, and use all lines as thick and short as possible to make
lower impedance. The output load line and input line shall be twisted or use shielded wire to improve noise
sensitivity.
(2) Remote sensing lines and remote ON/OFF control lines shall be twisted and separated from the output lines.
(3) Noise can be eliminated by attaching a capacitor to the load terminals.
(4) The recommended wire type, torque and crimp­type terminal :
Note 1 : When connecting some units, use of two pcs. of 0.8mm thick crimp
­type terminal is recommended for input terminal.
Note 2 : For recommended wire type, refer to wire maker recommended
allowable current and voltage drop.
Especially for 12V models, output current is large.
Thick diameter wire is recommended.
Recommended wire type and crimp­type terminal vary depending
on use conditions. Choice most appropriate wire type and
crimp­type terminal by refering to wire maker recommended
allowable current and voltage drop.
Note 3 : Output terminal is possible to install on arbitrary surface by customer.
(Refer to Fig.1 and Fig.2 for reference.)
Recommended to install single surface at same time to attach terminal cover for safety.
At shipment condition, screw is installed on top side (Fig.1). When installing on front side, please
reverse position of screw and terminal cover (Fig.2).
Do not recommend install dual surface at same time. It may cause touch each screw and cannot attach
terminal cover.
Fig.1 Top side screw (Shipment condition) Fig.2 Front side screw
22/23
D
(M AX)
t
(M AX)
M ounting pieces
(M AX)
1.0mm 1piece
0.8mm 2pieces
­
Output terminal M 5 Screws
2.0N·m (20.4kgf·cm) ~ 2.4N·m (24.4kgf·cm)
Recommended crimp­type terminal
M odel Recommended torque
Recommended
Wire
Input terminal M 3.5 Screws
1.0N·m (10.2kgf·cm ~ 1.6N·m (16.3kgf·cm)
AWG12­22
RWS1000B
RWS1500B
8.1mm
­