28
83507013 Rev G
1.2.6 Analog Voltage Programming and Monitoring
Analog inputs and outputs are provided at the rear panel for analog control of the power
supply. The Output Voltage and the Current can be programmed by analog voltage or by
resistor, and can be monitored by analog voltage. The power supply output can be
remotely set to On or Off and analog signals monitor the proper operation of the power
supply and the mode of operation (CV/CC).
1.2.7 Parallel Operation
Genesys
™ power supplies of the same Output Voltage and Current rating can be
paralleled in a master-slave configuration with automatic current sharing to increase
power available.
1.2.8 Output Connections
Output connections are made to rear panel bus-bars for models up to 60V and to a 4-
terminal wire clamp connector for models above 60V rated output voltage. Either the
positive or negative terminal may be grounded or the output may be floated. Models up
to 60VDC Rated Output shall not float outputs more than +/- 60VDC above/below
chassis ground. Models >60VDC Rated Output shall not float outputs more than +/-
600VDC above/below chassis ground. Contact factory for assistance with higher float
voltage applications.
Local or remote sense may be used. In remote sense, the voltage drop on the load wires
should be minimized. Refer to the specifications for the maximum voltage drop value.
1.2.9 Cooling And Mechanical Construction
The Genesys
TM
series is cooled by internal fans. At the installation, care must be taken
to allow free airflow into the power supply via the front panel and out of the power supply
via the rear panel. The Genesys
TM
power supplies have a compact and lightweight
package, which allows easy installation and space saving in the application equipment.
CAUTION
Observe all torque guidelines within this manual. Over-torquing may damage Unit or
accessories. Such damage is not covered under
manufacturer’s warranty.
