- 79 -
4. PARAMETER SETTING
(4) PARAMETER 1 - No. 14 “Steering SSC speed level”
This function starts to gradually limit the truck speed when the tire steering angle reaches 30
degrees left or right from the center position. It eventually limits the truck speed to a preset level when
the tire steering angle reaches 60 degrees.
(5) PARAMETER 2 - No. 11 “Truck speed limit rate during overdischarge”
PARAMETER 2 - No. 12 “Pump motor speed limit rate during overdischarge”
PARAMETER 3 - No. 1 “Overdischarge output level”
If the battery discharge indicator level drops to a preset level, an overdischarge signal will be output
from the LCD panel to the controller, thus limiting the drive motor and pump motor speeds.
Use PARAMETER 3 – No.1 to set the battery discharge indicator level at which the overdischarge
signal is output. You can specify the speed limit rates (percentage) in PARAMETER 2 - Nos. 11 and
12.
(6) PARAMETER 3 - No. 4 “Heater ON/OFF control”
This parameter item is displayed on the LCD panel, but its factory setting cannot be changed.
On LCD panels designed for use in a freezer, a heater is installed that maintains the correct LCD
temperature to keep the LCD panel functioning correctly.
This parameter item is factory set to OFF.
However, LCD panels for use in a freezer will switch the heater ON/OFF, according to the
temperature detected.
(7) PARAMETER 3 - No. 7 “Battery capacity”
Select the capacity of the battery installed in your truck. This setting will be used as the basis of the
calculations for the fuel consumption display.
This setting must be changed if the battery capacity is changed from the factory default setting.
If the capacity of the battery installed in your truck is not in the list, select the closest one.
ステアリング
SSC
特性
アクセルペダル踏み角に応じた指令速度
制限速度
[km/h]
タイヤ切れ角
[°]
CCW (
左旋回
)
CW (
右旋回
)
Steering SSC speed characteristics
Command speed according the angle of
the accelerator lever
Speed limits (km/h)
Steering wheel turned
counterclockwise (to the left)
Tire steering angle [°]
Steering wheel turned
clockwise (to the right)
Содержание FB-8 Series
