Factory Alignment Specification
Test Alignment Specification for MT62S-LA.doc (Page 11 of 16)
Appendix
o
How to download MEMC software
1. Connect PC to connector
PM3
with MSTAR ISP tool.
2. Power on the chassis.
3. Start
“ISP_Tool.exe”.
4. Select “Config”, set “ISP Slave Address” to “
0X94
”, set “I2C Speed Setting” to around 200K.
5. Click “Connect”, then “Device Type” will be shown if all the devices work well.
6. Click “Read”, and select the bin file for MST6M20.
7. Select “Auto”, and check “Blank”, “Program”, “verify”, “Exit ISP” and check “Erase Device”
with “File Area”.
8. Click “Run” to start programming.
9. “
Pass
” is shown while programming is finished, then reset the TV. Don’t power off TV during
programming.