TC Electronic Konnekt Live, Руководство пользователя

Страница: 10 / 60

phan line in
muting
non
muting
ch.select
push pan/user push pan/user push pan/user
+48V ch1/2 on
ch1/2
rear panel
ch1 ch2 3/4 user
mic|inst ch1 mic|inst ch2 monitor
phones
gain trim gain trim source level output level
made by
dsp total recall
P1 P2 P3
select
max max max min min min
-30 -30 -10 -10 O/L O/L pad|inst pad|inst
1 FireWire/Power LED indicator
When Konnekt is hooked up via FireWire, the blue
LED can indicate the following:
Steady lit: Sufficient power
Flashing: Uploading firmware, hardware error or
FireWire communication error.
Off: The Konnekt has no connection to the
driver, maybe because the driver is not
installed.
2 Mic/Inst ch1/ch2 on Combo XLR/Jack
Combo XLR/Jack inputs. Both XLR and 1/4 inch jack
can be used with this connector.
The XLR connection (balanced)
Connect a microphone and your signal is processed via
the IMPACT™ mic pre-amps.
- For condenser microphones activate phantom power.
see also (6) on the following page.
- The Input LEDs (4) indicate the level of the input
signal. If the red O/L LED (overload) is lit, your signal
is too “hot” and you should press “PAD/INT” to
attenuate the signal by 20 dB.
The 1/4 jack connection
-
Press PAD/INST to activate this circuit.
The 1/4 “jack part” of the connector is a high quality Hi-
Z circuit that is designed especially for connecting a
passive guitar pick-up system (e.g. Strat-type) directly.
The jack inputs on the front panel are unbalanced. If you
wish to connect balanced equipment using TRS jacks you
should connect via the line inputs on the rear panel.
Important!
If you use the 1/4 jack part of the Combo jack/xlr
connection PAD/INST must be set to “in”
position.
Connecting a turntable
A turntable can be connected to the Mic/Inst inputs by
using the supplied RCA to XLR cable. With a turntable
connected a RIAA filter must be inserted.
st ch1
L pad|inst
FRONT PANEL OVERVIEW
8