TC Electronic DB6, Руководство пользователя

Страница: 166 / 174

Appendix 2: DB6 GPI/O page
DB6 English Manual (2014-10-07) 163
Fig. 77.: Fig. 3: Setup “1 of 4”.
Use 1% precision resistors
Fig. 78.: Fig. 4: Setup “1 of 8”.
Use 1% precision resistors
In Table 2, voltages outside the limits mentioned
are to be considered invalid. No action is taken
if invalid measurements are made. GPI recall ac-
tion resumes when a stable, valid measurement
is detected again.
Mo
de U
se
r Pr
es
et N
o
S
ca
le
d T
ar
g
et / V
s
M
in t
yp / V
Ta
rg
et t
yp / V
M
ax t
yp / V
RL
3 RL
2 R
L1
1 of 2 1 1.000
(idle)
2.67 3.30 3.30 open
2 0.000 0.00 0.00 0.51 clos.
1 of 4 1 1.000
(idle)
3.20 3.30 3.30 open open
2 0.689 2.18 2.28 2.38 clos. open
3 0.548 1.71 1.81 1.91 open clos.
4 0.439 0.00 1.45 1.55 clos. clos.
1 of 8 1 1.000
(idle)
3.20 3.30 3.30 open open open
2 0.826 2.63 2.73 2.83 clos. open open
3 0.689 2.18 2.28 2.38 open clos. open
4 0.602 1.93 1.99 2.05 clos. clos. open
5 0.548 1.75 1.81 1.87 open open clos.
6 0.491 1.56 1.62 1.68 clos. open clos.
7 0.439 1.40 1.45 1.50 open clos. clos.
8 0.402 0.00 1.33 1.38 clos. clos. clos.
Table 2: GPI voltage windows
Notes:
►
“Idle” refers to the state when no input is con-
nected, or when the input is left floating.
► Rather than absolute voltage measurements,
the windows are defined as a fraction of the
supply voltage. This voltage can be measured
with a high impedance DMM on the D-SUB
pin 5 or 10.
► The table shows values as a fraction of the
supply voltage, and, as a guideline, typi-
cal voltages when the supply is 3.30 V. (If
the supply voltage is e.g. 3.315 V, the table
should be corrected by multiplying these val-
ues by 3.315/3.3).