6-2
OPERATING PROCEDURES
Model 8756
Operating Procedures
6
3. Install the driveshaft through the rear shell bearing in
the freezing cylinder and engage the hex end firmly
into the gearbox coupling. Make sure the driveshaft
fits into the drive coupling without binding.
Figure 6-3
WARNING!
Use extreme caution
when
handling the beater assembly.
The scraper blades are
very sharp and may cause injury.
4. Before installing the beater assembly, check the
scraper blades for nicks or signs of wear. If any nicks
are present, replace the blades.
Figure 6-4
5. If the blades are in good condition, place the rear
scraper blade over the rear holding pin on the beater.
Important!
The hole on the scraper blade must fit
securely over the pin to prevent costly damage.
Figure 6-5
Note:
Scraper blades should be replaced every
3 months.
6. Holding the rear blade on the beater, slide it halfway
into the freezing cylinder. Install the front scraper
blade over the front holding pin.
Figure 6-6
7. Before installing the beater shoes, check the shoes
for any nicks, cracks, or signs of wear. If defects are
present, replace the beater shoes.
11426
11529
11534
11427
Содержание Horizon 8756
