Taylor C723, Руководство по обслуживанию, Страница: 16 / 88

12
Introduction Model C723
Symbol Definitions
To better communicate in the International arena,
symbols have replaced the words on many of our
operator switches, function, and fault indicators.
Your Taylor equipment is designed with these
International symbols.
The following chart identifies the symbol definitions.
= SELECT
= ON
= OFF
= UP ARROW
= DOWN ARROW
= AUTO
= WASH
= MIX LOW
= MIX OUT
= MENU DISPLAY
= STANDBY
Power Switch
When placed in the ON position, the power switch
allows control panel operation.
Fluorescent Display
The fluorescent display is located on the front
control panel. During normal operation, the display is
blank. The display is used to show menu options
and notifies the operator if a fault is detected. On
International models, the display will indicate the
temperature of the mix in the hopper.
Indicator Lights
MIX LOW - When the MIX LOW symbol is
illuminated, the mix hopper has a low supply of mix
and should be refilled as soon as possible.
MIX OUT - When the MIX OUT symbol is
illuminated, the mix hopper has been almost
completely exhausted and has an insufficient supply
of mix to operate the freezer. At this time, the AUTO
mode is locked out and the freezer will be placed in
the STANDBY mode. To initiate the refrigeration
system, add mix to the mix hopper and touch the
AUTO symbol . The freezer will automatically
begin operation.
Standby Symbol
During long “No Sale” periods, the unit can be
placed in the Standby mode. This maintains product
temperatures below 40°F (4.4°C) in both the hopper
and the freezing cylinder, and helps prevent
overbeating and product breakdown.
To activate Standby, select the STANDBY key or
enter the access code for the Manager Menu and
select the Standby Mode option (see pages 17 and
20). The STANDBY symbol will illuminate,
indicating the Standby feature has been activated.
Using clean and sanitized hands, remove the air
orifice. Lubricate the o-rings located on the end of
the feed tube without the hole. Place that end of the
tube into the mix inlet hole.
Note: To resume normal operation, press the
AUTO symbol . When the unit cycles off, the
product in the freezing cylinder will be at serving
viscosity. Using clean and sanitized hands, turn the
feed tube over and place the end of the tube with
the hole into the mix inlet hole. Install the air orifice.