Taylor C723, Руководство по обслуживанию, Страница: 11 / 88

7
Model C723
Introduction
120411
General Installation Instructions
CAUTION: Only trained, authorized service
technicians should install this equipment. Failure to
comply will void the factory warranty.
The following are general installation instructions.
For complete installation details, please see the
checkout card.
ALL WIRING AND PLUMBING MUST
CONFORM TO NATIONAL AND LOCAL CODES.
INSTALL POTABLE WATER
CONNECTION WITH ADEQUATE
BACK-FLOW PROTECTION TO COMPLY
WITH APPLICABLE NATIONAL, STATE,
AND LOCAL CODES.
Site Preparation
Review the area where the unit is to be installed
before uncrating the unit. Make sure all possible
hazards to the user and the equipment have been
addressed.
Clearance: Air Cooled Units
The Model C723 air cooled unit requires a minimum
of 6” (152 mm) on the left and right sides and 0” on
the back.
The Model C723 unit equipped with top air discharge
requires 6” (152 mm) on the left side, 0” on the right
side, and 0” on the back.
DO NOT obstruct air intake and discharge openings.
Failure to allow proper clearance and airflow may
cause poor freezer performance and damage to the
machine.
For Indoor Use Only: This unit is designed to
operate indoors, under normal ambient
temperatures of 70
_
­ 75
_
F (21
_
­ 24
_
C). The
freezer has successfully performed in high ambient
temperatures of 104
_
F (40
_
C) at reduced
capacities.
This unit must NOT be installed in an area
where a water jet or hose can be used. NEVER use
a water jet or hose to rinse or clean this unit. Using a
water jet or hose on or around this equipment may
result in electrocution or equipment damage.
This unit must be installed on a level
surface to avoid the hazard of tipping. Extreme care
should be taken in moving this equipment for any
reason. Two or more people are required to safely
move this unit. Failure to comply may result in
personal injury or equipment damage.
Uncrate the machine. Inspect the unit for damage.
Report any damage to the Taylor factory
immediately.
This piece of equipment is made in the USA and has
USA sizes of hardware. All metric conversions are
approximate and vary in size.
Installer Safety
In all areas of the world, equipment should
be installed in accordance with existing local codes.
Please contact your local authorities if you have any
questions.
Care should be taken to ensure that all basic safety
practices are followed during the installation and
servicing activities related to the installation and
service of Taylor equipment.
S
Only authorized Taylor service personnel
should perform installation and repairs on
the equipment.
S
Cord Connected Units: Only Taylor
authorized service personnel may install a
plug on this unit.
S
Authorized service personnel should consult
OSHA Standard 29CFRI910.147 or the
applicable code of the local area for the
industry standards on lockout/tagout
procedures before beginning any installation
or repairs.
S
Authorized service personnel must ensure
that the proper PPE is available and worn
when required during installation and
service.
S
Authorized service personnel must remove
all metal jewelry, rings, and watches before
working on electrical equipment.