Tatu Marchesan RTA-6, Инструкция по эксплуатации

Страница: 16 / 35

15
SET SET
SET SET SET-UP INSTRUCTIONS
-UP INSTRUCTIONS
-UP INSTRUCTIONS -UP INSTRUCTIONS -UP INSTRUCTIONS
The following instructions must be observed carefuly to get the a better
performance at work.
Setting-up the Tractor
The adition of water ballast in the tires, are the ways more used to increase the
traction to the soil and giving a better stability to the tractor. Verify if the tractor is in
full conditions of use.
Coupling to the Tractor
- Do the coupling in a level and firm place in the following manner:
- Fully lower the hydraulic arms of the tractor; maintaining a height of 350 mm
from the ground, until the middle of the joints of the lower arms.
- Pull the upper arm (3rd point) from the tractor.
- Bring the tractor of the Tatu Back Hoe close enough to link with the axle.
- Join the axle to the tractor, securing it with the bolt.
- Start the motor of the tractor and engage the power point, starting in low
rotation.
- Move the levers of the stabilizing arms (shoes) with short and even
movements, raising the Tatu Back Hoe to the coupling level (+/- 350 mm).
- Very carefully work the levers of the arm boom and the bucket until they
are on the ground, leaving the Tatu Back Hoe level in order to facilitate the
coupling.
- Turn off the motor and disconnect the power point.
- Remove the axle from the tractor.
- Couple the Tatu Back Hoe to the tractor, starting with the lower arms. Use
the gaps (holes) in the regulating rod and the guide to facilitate the linking to
the 3rd point. See picture on the next page.
Note: THE COUPLING SEQUENCE DESCRIBED BELOW DOES NOT TAKE INTO ACCOUNT
THE PRESENCE OF FACILITIES SUCH AS CRANES, ETC., FOR RAISING THE TATU BACK
HOE.
Note: FROM THIS POINT ON, BE SURE TO USE OF THE LEVERS AND RESPECTIVE CILYNDERS
CORRECTLY.
Attention: BE CAREFUL NOT TO MOVE THE ROTATION LEVER.