Tatoma EMV-10, Инструкция по эксплуатации

Страница: 36 / 68

VERTICAL TOWED MIXER
3 HANDLING THE MIXER
Before starting the mixer, the person in charge should:
•
Be suitably instructed in its use.
•
Should be informed as to the dangers that are involved in its use and
the safety measures incorporated to avoid them.
•
Should be informed of the safety measures that should be adopted for
the protection of personnel and the actions that should be carried out
when handling the machine
This machine is the result of many years of experience acquired by
TATOMA, with its strong point being the high level of efficiency when
shredding and mixing the product, in addition to minimum wear and tear
accompanied by the low maintenance cost.
The use of the mixer by personnel who have been instructed
to respect the rules and indications contained in this
instructions manual will prolong the life of the machine and
avoid the appearance of breakdowns
The following sections will make reference to the control elements,
instruments and the different elements of the mixer already described in the
section 1 and 2 of this document, and should be previously revised before
reading this section.
3.1. STARTING UP
To start up the mixer the following steps should be taken:
1. Check the exterior condition of the machine and the state of the
different mechanism and protectors and guards. Then connect the
battery
Should any of the safety protectors or guards be
deteriorated or broken, they should be immediately
repaired or replaced before starting to work with the
machine.
2. Hook up the mixer to a tractor with the power needed (see section 5)
The following steps should be followed:
ƒ
Bring the tractor towards the mixer.
Check no one is between the tractor and the mixer.
When carrying out a reverse manoeuvre bring the
tractor to the mixer.
ƒ
Adjust the height of the mixer hitch with the foot rest that is
fitted on the mixer
ƒ
Hook up the adequate blocking means
Handle the hooking up elements of the mixer with
working gloves.
3. Pick up and completely fold away the foot rest to avoid contact with
obstacles when running.
4. Stop the tractor.
5. Connect the cardan to the PTO by means of the following steps
ƒ
Check that the mixer has been correctly hooked up
ƒ
Ensure that the tractor PTO is stopped
ƒ
Remove the cardan guard momentarily and connect the PTO,
fix in position using suitable devices
ƒ
Replace the cardan protection to its working position and
ensure that it is correctly placed.
When working, the PTO or the transmission shaft
should always be protected as there is a danger of
becoming trapped
Do not use loose clothes when carrying out the
operation and always handle the Mixer PTO with
work gloves.
Page 31