Tatoma EMV-10, Инструкция по эксплуатации

Страница: 68 / 68

TOWED VERTICAL MIXER
Page 63
SCALE
Screen does not turn on
or the following
inscription appears on
screen:
Lo-bAT
- Burnt safety fuse
- Inverted connection
- Tractor plug is dirty, rusted,
or in bad condition.
- Discharged battery
- Cut cable
- Check the fuse in the battery
box.
- Invert the cable.
- Clean plug or change it.
- Charge battery
- Connect cable.
Screen turns on and
shows Er-OuT - Short circuit alarm or scale
not operating properly
- Make sure the cables are well
insulated and that the scale is
operating properly.
Unstable figure appears
on screen
- Cut cell cable
- Humidity in the cell
connections
- One or several damaged
cells
- Check cell cable and repair.
- Thoroughly clean connection
cables of the cells in the box.
- Change damaged cells.
Scale does not weigh
accurately
- Error in the cell assembly
- Possible contact between the
chassis or axle and the tub.
- Incorrect calibrated value
- Verify that the cells are correctly
placed.
- Make sure that there is no
contact between the chassis or
axle and the tub.
- Calibrate
The screen reads:
Cxxxx-L
Cxxxx-L
- Empty weight system not
regulated
- Regulate the empty weight
following the instructions in the
manual.
The screen reads:
Or-L
Or-L
- Broken cell cable, damaged
ground wire or broken cells
due to hits or deformation
- Check box connection, verify
cell cables, or make sure that
there are no damaged cells (1).
(1) To check if there are any damaged cells, disconnect them all and then plug them in one by
one, recording the data that appears on screen. If any of the previous symbols appears on
the screen, this indicates that the cell is damaged.