Tascam PA-R100, Инструкция по эксплуатации

Страница: 71 / 96

Controlling Other Components
En-71
Components that are connected via
u
are controlled by
pointing the remote controller at the AV receiver, not the
component. This allows you to control components that are
out of view, in a rack, for example.
You can reset a
REMOTE MODE
button to its default
remote control code.
You can reset the remote controller to its default settings.
By pressing the
REMOTE MODE
button that’s been
programmed with the remote control code for your
component, you can control your component as described
below.
For details on entering a remote control code for other
components, see “Entering Remote Control Codes”
(
➔
page 70 ).
Controlling a TV
TV is preprogrammed with the remote control code for
controlling a TV that supports the p
*1
(limited to
some models). The TV must be able to receive remote
control commands via
p
and be connected to the
AV receiver via HDMI. If controlling your TV via
p
doesn’t work very well, program your TV’s
remote control code into
TV
and use the TV remote mode
to control your TV.
Use the following remote control codes:
`
11807/13100/13500 :
TV with
p
Controlling Apple TV
By programming the supplied remote controller with the
appropriate remote control code, you can use it to operate
your Apple TV.
Use the following remote control codes:
`
02615 :
Apple TV
Remote Control Codes for Components
Connected via RI
1
Make sure the component is connected with an u
cable and an analog audio cable (RCA).
See “Connecting RI Components” for details
(
➔
page 16 ).
2
Enter the appropriate remote control code for a
REMOTE MODE button, by referring to the
previous section.
`
42157 :
Cassette tape deck with u
`
81993 :
Dock with
u
3
Press the
REMOTE MODE
button, point the
remote controller at the AV receiver, and operate
the component.
Resetting the REMOTE MODE Buttons
1
While holding down the REMOTE MODE button
that you want to reset, press and hold down HOME
until the remote indicator lights (about 3 seconds).
2
Within 30 seconds, press the
REMOTE MODE
button again.
The remote indicator flashes twice, indicating that the
button has been reset.
Each
REMOTE MODE
button is preprogrammed
with a remote control code. When a button is reset, its
preprogrammed code is restored.
Resetting the Remote Controller
1
While holding down
RECEIVER
, press and hold
down
HOME
until the remote indicator lights
(about 3 seconds).
2 Within 30 seconds, press RECEIVER again.
The remote indicator flashes twice, indicating that the
remote controller has been reset.
Controlling Other Components