Tascam PA-R100, Инструкция по эксплуатации

Страница: 34 / 96

Turning On & Basic Operations
En-34
Error Messages
While Audyssey 2EQ ® Room Correction and Speaker
Setup is in progress, one of the error messages below may
appear.
The options are:
`
Retry :
Try again.
`
Cancel :
Cancel Audyssey 2EQ Room Correction and Speaker
Setup.
• Ambient noise is too high.
The background noise is too loud. Remove the source of
the noise and try again.
• Speaker Matching Error!
The number of speakers detected was different from that
of the first measurement. Check the speaker connection.
• Writing Error!
This message appears if saving fails. Try saving again. If
this message appears after 2 or 3 attempts, contact the
dealer from whom you purchased this unit.
• Speaker Detect Error
This message appears if a speaker is not detected. “ No ”
means that no speaker was detected.
Tip
• See “Speaker Configuration” for appropriate settings
(
➔
page 11 ).
Changing the Speaker Setup Manually
You can manually make changes to the settings found
during Audyssey 2EQ Room Correction and Speaker
Setup.
See also:
• “Speaker Configuration” (
➔
page 50 )
• “Speaker Distance” (
➔
page 51 )
• “Level Calibration” (
➔
page 51 )
Using a Powered Subwoofer
If you’re using a powered subwoofer and it outputs very
low-frequency sound at a low volume level, it may not be
detected by Audyssey 2EQ Room Correction and Speaker
Setup.
If the “
Subwoofer ” appears on the “ Review Speaker
Configuration ” screen as “ No ”, increase the subwoofer’s
volume to the half-way point, set it to its highest crossover
frequency, and then try running Audyssey 2EQ Room
Correction and Speaker Setup again. Note that if the
volume is set too high and the sound distorts, detection
issues may occur, so use an appropriate volume level. If the
subwoofer has a low-pass filter switch, set it to Off or
Direct. Refer to your subwoofer’s instruction manual for
details.
Retry
Cancel
AUDYSSEY
2EQ: Auto Setup
Ambient noise is too high.
Error message