Tascam PA-R100, Инструкция по эксплуатации

Страница: 65 / 96

Advanced Operations
En-65
Adjusting the Volume for Zone 2
■
Operating on the remote controller
■
Operating on the AV receiver
Muting Zone 2
■
Operating on the remote controller
Tip
• To unmute, press ZONE2 followed by MUTING again. Zone can
also be unmuted by adjusting the volume.
Adjusting the Tone and Balance of Zone 2
Note
• Only analog input sources are output from the
ZONE 2
PRE/LINE OUT jacks. Digital input sources are not output. If no
sound is heard when an input source is selected, verify that the
source is connected to an analog input.
• You cannot select different AM or FM radio stations for your
main room and Zone 2. The same AM/FM radio station will be
heard in each room. Namely, if you have selected an FM station
for the main room, that station will also be output in Zone 2.
• When you have selected NET or USB as input selector, the last
selector selected will be set for Main room and Zone 2.
• When Zone 2 is activated and its input selector is selected, the
power consumption of standby mode slightly increases.
• While Zone 2 is on, u functions will not work.
• When setting the AV receiver to standby mode while Zone 2 is
active, the Z2 indicator is dimly lit.
• Activating Zone 2 in the main room when the listening mode is
set to Pure Audio ( European models ) will automatically switch
it to Direct.
• The Zone 2 level, balance, and tone functions have no effect on
the ZONE 2 PRE/LINE OUT jacks when the “ Zone 2 Out ”
setting is set to “ Fixed ” (
➔
page 60 ).
The 12V triggers A, B, and C can be used to turn on 12V
trigger-capable components automatically when they are
selected as the input source. The triggers can be set so that
they activate themselves once a connected component is
selected as the input source for the main room, Zone 2 or
any combination of rooms. When triggered, the output
from a
12V TRIGGER OUT goes high (+12 volts and
150 milliamperes max. at
12V TRIGGER OUT A
;
+12 volts and 25 milliamperes max. at
12V TRIGGER
OUT B and C ).
See “12V Trigger A/B/C Setup” (
➔
page 59 ).
Hookup
• Use a miniplug cable to connect the AV receiver’s 12V
TRIGGER OUT A , B , or C jack to the 12 V trigger
input of a connected component.
1
Press ZONE2 .
2
Use VOL
q
/
w
.
1
Press ZONE 2 (the Z2 indicator on the AV
receiver’s display flashes).
2
Use
MASTER VOLUME
control within 8 seconds.
1 Press ZONE2 followed by MUTING .
1 On the AV receiver, press ZONE 2 .
2
Press the AV receiver’s TONE repeatedly to select
“Bass”, “Treble” or “Balance”.
3
Use
–/+
to adjust the bass, treble or balance.
• You can boost or cut the bass or treble from –10 dB
to +10 dB in 2 dB steps.
• You can adjust the balance from 0 in the center to
+10 dB to the right or +10 dB to the left in 2 dB
steps.
Using the 12V Triggers