Tascam DM-3200, Руководство пользователя, Страница: 21 / 26

DM-3200 Release Notes
TASCAM DM-3200 Release Notes V1.50
1
The following mixer settings cannot be changed while
automation data is being re-played.
Surround mode
Grouping setting
Channel link setting
Pan switch setting [Set by
SHIFT + OUTPUT ASSIGN ]
If you try to change the above settings, a pop-up message
“
cannot do this while automation is running ” will appear
and the operation will be denied.
•
•
•
•
Settings prohibited to change during automation re-play
The following parameters are now captured and re-played
as the Initial Status of the automation (please see “Initial
Status” on page 32 of DM-3200 Automation Guide).
Trigger source of the compressor
Trigger source of the gate
ROUTING>INPUT
screen setting
ROUTING>OUTPUT
screen setting
ROUTING>INSERT
screen setting
Pan mode setting
Surround pan mode setting
Direct assignments setting
Pan gang button setting
Digital trim value setting
Phase setting
•
•
•
•
•
•
•
•
•
•
•
Mono switch setting
Channel delay value setting
Pre/post setting of the channel delay
Level setting of BUSS/AUX signal to stereo buss
Pan setting of BUSS/AUX signal to stereo buss
With these additions, all of the parameters that can be
stored as snapshots are now captured and re-played as the
Initial Status.
•
•
•
•
•
Additional parameters that are re-played as Initial Status
Expanded dynamic automation function
The following parameters can now be captured and
re-played by the dynamic automation function of DM-3200
(please see “Automated Controls” on the page 4 of the
DM-3200 Automation Guide).
Image
Image parameter of the linked channel (please see “Pan
and balance settings” on page 71 of the DM-3200
Owner’s Manual).
Effect
Common effect parameters ( TYPE , INPUT , MIX , BYPASS ,
OUTPUT
) and TASCAM effect parameters (please see
“Setting up the effects” on page 82 of DM-3200 Owner’s
Manual).
Assignments
This includes, in addition to the buss assignment and
stereo buss assignment, the AUX 1-2 assignment from the
BUSS and STEREO BUSS, surround assignment and ON/
OFF setting of CSP/LFE speakers (please see “Channel-
to-buss assignment” on page 51 and “Assigning channels
to surround busses” on page 75 of the DM-3200 Owner’s
Manual).
NOTE
When any of the above mentioned parameters is a
continuous variable, the Revert function is applied to it.
On the AUTO CONFIG screen, each of these addi-
tional parameters is related to an item as shown
below (please see “AUTO CONGIG” on page 14 of the
DM-3200 Automation Guide).
parameter item
IMAGE
Assign Swtch
Effect 1 parameters
Effect 2 parameters
PAN/BAL
BUSS ASSIGN
EFFECT 1
EFFECT2
Additional dynamic automation parameters