11
TIPs
：
Battery
Receiver
Video
Flight Control
6. Gimbal Working Mode
ASSEMBLY SECTION
5
Power Supply:3S-6S Li (11V-26V)
* If you choose a battery to power up the gimbal and
multi-rotor, please make sure this battery meets
requirements of both components.
1.
Common Receiver
: connect the corresponding port of
common receiver to CHI-CH7 channels of gimbal controller.
Set related parameters in RECEIVER TYPE and RC
MAPPING in assistant software.
2
.
FutabaSBUS Receiver/ SBUS-2 Receiver
: connect
SBUS receiver to CH7 channel of gimbal controller. Set
related parameters in RECEIVER TYPE and RC MAPPING
in assistant software.
3.
Satellite Receiver
: connect Satellite receiver to DSM
port of gimbal controller. Set related parameters in
RECEIVER TYPE and RC MAPPING in assistant software.
If binding is not successful in DSM2-1 or DSMX-1,
please choose DSM2-2 or DSMX-2 to bind.
Connect the wireless video transmission module to AV
port through a 3.5mm AV cable.
Gimbal can work without Tarot Multi-rotor Flight Control
Module, but the performance might be inuenced:
1. Angle offset might occur when the accelerated state lasts
for a long time.
2. In AL Mode, drifts might occur in pan angle due to gyro offset.
If you are pursuing a perfect performance, please connect the
gimbal and Tarot Multi-rotor Flight Control Module to the CH8
channel of gimbal controller.
You should select a three-positioned switch in the transmitter for working
mode. Please connect the corresponding port of the receiver to any
channel ofCH1-CH7channels of the gimbal controller.Set RC MAPPING
in the assistant software. For different positions, use endpoint ne tune
function to set. Please refer to the MODE Channel section in assistant
software for detailed information.
