9
Attentions
：
4. Video Signal Transmission
Attention
：
①
Please ensure the wireless video transmission module and gimbal controller
module has connected.
②
Please use the standard AV cable, make sure the solder procedures are correct
and the cables are insulated without short circuit.
③
Choose an external battery for the transmission module.
If you want to control the camera through a 2-position switch.
Please set your transmitter and observe the cursor of PVC
channel in the assistant software. Either taking-photos or
recording can be applied in this circumstance.
You should prepare a wireless video transmission module and connect the
cables according to the diagram below.
Step One: Solder Power/Video Signal/Ground Cable to the Wireless Video
Transmission Module.
Step Two: Connect the other side of the gimbal AV cable to the video signal
port of gimbal controller module.
ASSEMBLY SECTION
5
